multiACE Addon
Monitor and control every ACE filament unit on your Snapmaker U1, including drying and toolhead assignment
Printer Tools controls multiACE, the Snapmaker U1's automatic filament unit system, over the same local connection as your printer. See every connected unit's slots, temperature and humidity, assign units to toolheads, load or unload filament, and start or stop drying, all from one dashboard.
Supported devices
Yhteys ja protokolla
| Transport | Local API on original firmware, or the paxx12 community firmware |
| Models | Snapmaker U1 only |
| Note | paxx12 is an independent community project, not affiliated with Snapmaker |
| Away from home | Connect over a VPN back to your network, Printer Tools doesn't use any Snapmaker cloud service |
Mikä on tänään vahvistettu
- ✓Per-slot filament details for every connected unit: material, brand, color and whether a spool is loaded
- ✓Unit temperature, humidity and connection status
- ✓Load and unload filament to a specific toolhead, and assign a toolhead to a specific unit
- ✓Start or stop drying with a target temperature, and see the remaining drying time
- ✓Support for multiple connected units and up to four independent toolheads
Ominaisuusmatriisi
| Ominaisuus | Tila | Huomiot |
|---|---|---|
| Connection & discovery | Saatavilla | Uses the Snapmaker U1's own local connection; detected automatically once the printer is added. |
| Live telemetry | Saatavilla | Per-slot filament, unit temperature, humidity and connection status for every connected unit. |
| Remote control | Saatavilla | Load, unload, assign toolheads and start or stop drying, where the connected units support it. |
| Multiple devices | Saatavilla | Tracks multiple connected units and up to four independent toolheads at once. |
Tunnetut rajoitukset
- !Available where the connected units are supported by the firmware in use; capabilities can vary between the original firmware and paxx12, and between firmware versions.
- !paxx12 is an independent community firmware project, not affiliated with or endorsed by Snapmaker.
- !Only available on the Snapmaker U1; other Snapmaker models aren't covered by this integration.
Usein kysytyt kysymykset
Does multiACE work on both original firmware and paxx12?
multiACE integration depends on which connected units are supported by the firmware you're running; support can vary by firmware version.
Can I control drying from Printer Tools?
Yes, start or stop drying with a target temperature directly from the unit's card, and see the remaining drying time while it runs.
How many toolheads and units does this support?
Up to four independent toolheads and multiple connected ACE units, matching the U1's multi-material design.
Is paxx12 an official Snapmaker firmware?
No. paxx12 is an independent community firmware project for the U1, not affiliated with or endorsed by Snapmaker. Printer Tools supports both the original firmware and paxx12.